Come on by Doc.

Bit

Thanks fellows I do appreciate the kind words.


Bit

http://i127.photobucket.com/albums/p157 ... cks001.jpg

http://i127.photobucket.com/albums/p157 ... cks002.jpg

http://i127.photobucket.com/albums/p157 ... cks003.jpg

http://i127.photobucket.com/albums/p157 ... cks004.jpg

http://i127.photobucket.com/albums/p157 ... cks005.jpg

http://i127.photobucket.com/albums/p157 ... cks006.jpg

http://i127.photobucket.com/albums/p157 ... cks007.jpg

here are some pics of the trucks

No prpblem Doc glad to be at your service . The 79 to 91 is the best years after that they started weaking the frames and when they went to the removeable crossmember 05 I think they were a disater. I too have considered the long bed Idea the 2 problems that I see are simply cut the factory rails ou...

If you buy a LTD that is a running driving car and you have some welding skills you can build that truck very cost effective, I would say you could do that cheaper than anything out there. As for the newer Crowns ( LTD ) buyer beware as these frames are not near as strong as the older ones and that ...

I will see if I can get Sam to post some pics of our LT1 as I do not know how anymore.

Bit

Hey Ice wich truck is it?

Bit

You can call me and I will try and answer your questions.

I have built 2 of these. I generally go to bed around 9 eastern so please consider that. 336 240 3708.

Bit

Pete is honest if it is Pete from Georgia, Maybe a little slow but I have not heard of him cheatting anyone.

Bit

Hey Mike have you got a side shot of your uni?

Bit

Yeppers

Bit

http://groups.msn.com/SlicksN-C-Chapter ... hotoID=315 Here is a pic of the LTD uni. Looks to me like the crossmember swap will not be this low but I am not sure.

Bit

Well we have a ltd uni that has been to the mtns twice and the beach twice to the race city fun 2 times and so on and so forth and it has preformed very well.

Bit

Thanks JC and same goes here . Steve have you ever straitened the frame on one of these trucks with the wheel drove up through the floor board? I have and the way I see it if the rack will withstand that kinda blow or have a set of 35's on it I don't think a staight axle will hurt it much. I also st...

While I would not disagree with what has said here I would add that and I am assuming that a new crosmember will be added to the truck for rack to bolt to the new Ford trucks and Dodge trucks now come with a rack and I have not seen any failures in these trucks The Aerostar van has the most severe a...

BP has a lot.

Bit

Just testing

Bit

Hey Rick myself Gene Davis, Scott, and Sam are all in Lexington also.

Bit

Well I am here too.


Bit