Hi everyone! Doing a front disk brake swap on a 64 f100. I am looking for a kit with a master and booster included. What is the best quality kit out there? Thanks!

I think it was $400-500. It was only 2 years ago but a lot has happened since then.

Had truxedo make mine. It is the lowpro style

First thing I did after replacing the consistent voltage reg was replace the sensor. Didn't work. Over it. Put the old cvr back in. I will just buy a quad gauge eventually and switch it over to 12 volt. The kits I am looking at are spendy do to the fact you replace the float, oil pressure, and temp ...

Thanks 9Fingers!

Thanks 9Fingers!

forgot to up date this. Yeah I have one. Used it, an aftermarket mechanical temp gauge and a Mr. Gasket thermo radiator cap. Every one said the system is working properly. So that means the factory gauge is off. Is there any adjustment other than buying resistors from an electric supply store?

Thanks shipwrecked!

Finally got out to the shop to work on the 66. The straight six location on a 1966 f100 is on the bottom bolt of the throttle bracket. Thanks again Guys for the replies!

Anyone have pics of a straight six location?

Thanks Mr. Jones! I appreciate it very much!

Thanks for the reply!

I have looked and looked for images of where the ground goes to the cab on a 66 f100 2wd had a 240. the p.o. never had one on it when I got it. I have read that it goes from the drivers side head to the cab near the throttle cable bracket. I can't find any pictures. I just like having things in thei...

Yeah I have an aftermarket temp gauge and a Mr. Gasket termocap on order. I was going to try and make sure the temp is good before messing with the stock gauge. Everything is new so I can't for see anything wrong. Just frustrating buying new parts that don't work as they should. I have adjusted fuel...

Am I just overthinking this? Do they mean coil up some thinner gauge wire and adjust the length till it's in spec.?

Hi. I replaced my consistent voltage regulator with a Scott Drake one Just because my fuel gauge was a little off. Fuel seems good but now my temp gauge reads high. I have tried a different temp/ speedo cluster I had laying around. Same problem. The truck has a new thermostat (180*), aluminium radia...

Hi Jim, Sorry I just seen this reply! Thanks for the offer! I measure one from a long box and it was way to long. Is yours off a short box truck?

I was Just thinking about this again and I never really got an answer. I have a manual valve to shut off the flow to the heater. My question is what is air supposed to do when the fan is running in the in position? It runs when turned on but no air comes out anywhere until I pull the switch out.

Thanks for all the info!

Hi Guys! I am wondering if any companies made saddle tanks for short box truck? I know ford did not . The ones that sit on the outside of the frame and fill up threw the rear wheel wells. I have seen long boxes with them but, I have measured them and they are to long to stuff under my short box. I k...