How do you take the speedometer needle off the gauge? Im rebuilding my clusters and i think the needle spun off cause its not sitting at 0 mph anymore. Now it falls just straight South.
It may be OK since i haven't driven it to see if it does work but in case it doesn't I rather do it before i put everything back together.
Taking speedometer needle out
- "Whitey Ford"
- Posts: 701
- Joined: November 8, 2007, 11:12 am
- Location: Jackson, MS
Taking speedometer needle out
Girls love a pick-up man.
-
- Posts: 11470
- Joined: July 11, 2006, 11:28 am
- Location: Dove Creek, Co. elevation 6842
Re: Taking speedometer needle out
the needle is pressed on the shaft
i took one off once to paint, they are very thin and bend easily
you can test it by spinning the cable with a drill motor
i took one off once to paint, they are very thin and bend easily
you can test it by spinning the cable with a drill motor
1966 F250 4x4
1964 Rambler Ambassador 990
Rest in peace departed Slick family members
Cam Milam
Lesley Ferguson
Steve Lopes
John Sutton
1964 Rambler Ambassador 990
Rest in peace departed Slick family members
Cam Milam
Lesley Ferguson
Steve Lopes
John Sutton
- "Whitey Ford"
- Posts: 701
- Joined: November 8, 2007, 11:12 am
- Location: Jackson, MS
Re: Taking speedometer needle out
OK. yeah i was painting mine while itwas on and cleaning the cluster face then when the needle returned it was pointing straight down. Wondering if i messed something up
Girls love a pick-up man.
Re: Taking speedometer needle out
I'm not looking at mine, but isn't there a little stop it usually sits against for zero?
- "Whitey Ford"
- Posts: 701
- Joined: November 8, 2007, 11:12 am
- Location: Jackson, MS
Re: Taking speedometer needle out
Hate to bring this up again but how does the needle stop at zero? Once im going the needle stays nice and steady but not sure if the mph is correct now. Its damn near straight down but if i start moving its moving but i know its off at 0-20 or so.
Girls love a pick-up man.
- unibody madness
- Posts: 2140
- Joined: December 4, 2008, 4:33 pm
- Location: Paradise,CALIFORNIA 95969
Re: Taking speedometer needle out
You can correct it by spinning it all the way around until you make up the difference either at the stop or by holding the back of the shaft and spinning it back to zero.
Turk build thread at:
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!