Thanks to Blackwaterforge I am in negotiations to pick up a tri power manifold for my y-block.
Anyone in the Birmingham area able to take a look at it for me?
Seller says it has sat on a shelf for a few years but ran when he took it off the motor....
Any and all help will be appreciated.
John
alabama help
- unibody madness
- Posts: 2140
- Joined: December 4, 2008, 4:33 pm
- Location: Paradise,CALIFORNIA 95969
alabama help
Turk build thread at:
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
Re: alabama help
PM sent
Re: alabama help
John,
Did you decide to spring for the tri power? Looked like a great deal.
Rich
Did you decide to spring for the tri power? Looked like a great deal.
Rich
61 T Bird Convertible
1953 Ford Customline 2 door
1953 Ford Customline 2 door
- unibody madness
- Posts: 2140
- Joined: December 4, 2008, 4:33 pm
- Location: Paradise,CALIFORNIA 95969
Re: alabama help
Richard
having a member look at it today.
If you run into uncle skip at pate tell him I sent him a p.m.
enjoy the side trip
having a member look at it today.
If you run into uncle skip at pate tell him I sent him a p.m.
enjoy the side trip
Turk build thread at:
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!