Should i lower the '66?!?!?!? (poll)
- unibody madness
- Posts: 2147
- Joined: December 4, 2008, 4:33 pm
- Location: Paradise,CALIFORNIA 95969

I don't think lowering it that much is needed. I agree it looks good the way it is. if anything lower it no more than an inch in the front only
Turk build thread at:
http://slick60s.com/viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
http://slick60s.com/viewtopic.php?f=32&t=18944
It does not matter what you think, it only matters what you do about it!
I like mine to sit about stock [img][img]http://i1111.photobucket.com/albums/h46 ... on/lt1.jpg[/img]
[/img]
100 Years from now it will matter
I'm a big fan of the lowered look on ALL slicks, however there are some combo's of wheel tyre + colour that just look cool as they are. Most black slicks look cool just being black and I think yours is one of them, so I'd leave it as it is!
You could always just reset the springs a bit lower + cut a coil in the front, that way if you don't like it a set of secondhand springs is all thats needed to put it back where it was.
You could always just reset the springs a bit lower + cut a coil in the front, that way if you don't like it a set of secondhand springs is all thats needed to put it back where it was.
-
blackagatha
- Posts: 2582
- Joined: March 10, 2007, 12:49 am
- Location: Arizona
YAY Foodstick!!! 'bout time somebody hit it with a photo-slam.
There's no way to tell without having something to look at!!!!
Personally, i dig it, but being i like to use mine as a truck too, I would (and WILL when I do the deed) make it able to resume a normal-ish height.
There's no way to tell without having something to look at!!!!
Personally, i dig it, but being i like to use mine as a truck too, I would (and WILL when I do the deed) make it able to resume a normal-ish height.
'63 with 390 & lots of juice. But never enough. Always want more.











