1963 F700 rams horns

mrgoob · Post by **mrgoob** » July 1, 2011, 3:05 pm

63 F700 rams horns on a V8. I lost all the id numbers so I don't know which motor was in the truck.It did not have the crossover like on my 292. I want to know if these rams horns will fit my 292. Is there an easy way to tell without me going back to the salvage yard? Thanks.

charliemccraney · Post by **charliemccraney** » July 1, 2011, 3:12 pm

They will fit your 292 if the mounting holes look to be in a straight line. The Lincoln exhaust has a noticeably staggered pattern and will not fit your 292.

ICEMAN6166 · Post by **ICEMAN6166** » July 1, 2011, 7:07 pm

1962 f700 292HD rams horns, holley 4 v, extra deep oilpan, air compressor. its all good stuff to take and if it a parts truck i am interested in the 3 bottom/dual top pulleys.

mrgoob · Post by **mrgoob** » July 1, 2011, 9:22 pm

Thanks for the replies.

Iceman-amazing how you always have a picture of anything asked. The exhaust on this F700 looked different. It has a bar between the horns above the center bolt. I accidentally deleted the info I had on this motor but I will get it again and let you know about the pulleys as well. Looked like the inner fenders are the same as my F250 4x4 too-is that right?

ICEMAN6166 · Post by **ICEMAN6166** » July 1, 2011, 9:25 pm

yes, the core support and inner fenders fit the 4x4s

RlCHARD CRANlUM · Post by **RlCHARD CRANlUM** » July 3, 2011, 3:13 pm

All of the ram horn manifolds I've seen that had a bar across them were Lincoln.. I'm not sure when they stopped putting the 368 Lincoln in the big slicks, but most I've seen were 61-63.

charliemccraney · Post by **charliemccraney** » July 3, 2011, 3:29 pm

Yep, bar between the humps is a Lincoln.