I put this in classifieds too but I think it might do better here.
There is a '59 F350 at the Atlanta North Pull A Part. I looked at it a few weeks ago but haven't been back since. It had a Y-Block at that time that could be a 312 based on the casting number. It's definitely not the original motor. The part numbers don't match the year model. I might go back tomorrow to see if I can determine what it is. I don't know if anything else will swap to our trucks. I don't really have room for the motor at this time so if someone can rescue it, it will be great!
Heads up to Atlanta area folks.
- charliemccraney
- Posts: 1743
- Joined: July 9, 2008, 10:02 pm
- Location: Lawrenceville, GA
Heads up to Atlanta area folks.
Lawrenceville, Ga
1961 F100 Unibody
318 Y-block (292 +.070 bore, +.170 stroke), FMS T5-Z w/Mustang 10.5" diaphragm clutch.
1961 F100 Unibody
318 Y-block (292 +.070 bore, +.170 stroke), FMS T5-Z w/Mustang 10.5" diaphragm clutch.
- charliemccraney
- Posts: 1743
- Joined: July 9, 2008, 10:02 pm
- Location: Lawrenceville, GA
Well, last weekend, I pulled the pan and found that it was a 312. I went to get it yesterday and the truck had been crushed during the week . I hope someone got it.
However, there is a Mercury with a Y-block, which is also possibly a 312. I didn't have time to pull the pan.
However, there is a Mercury with a Y-block, which is also possibly a 312. I didn't have time to pull the pan.
Lawrenceville, Ga
1961 F100 Unibody
318 Y-block (292 +.070 bore, +.170 stroke), FMS T5-Z w/Mustang 10.5" diaphragm clutch.
1961 F100 Unibody
318 Y-block (292 +.070 bore, +.170 stroke), FMS T5-Z w/Mustang 10.5" diaphragm clutch.