Sheet Metal Parts
-
- Posts: 3
- Joined: July 4, 2016, 7:33 am
Sheet Metal Parts
Anyone have any experience with LMC's new "Complete Floor Pan Assembly"? It would save a BUNCH of time if the quality was there...
-
- Posts: 906
- Joined: August 12, 2009, 9:44 am
- Location: Ohio
Re: Sheet Metal Parts
I've always looked for a complete better cab when dealing with rust issues. I'm in the rust belt and it can take some time, but I've always been able to locate some pretty good original ford metal without having to travel too far. $1399 will cover the cost of a cab plus a lot of gas. You will still have a lot of work in replacing a complete floor as you have to keep the rest of the cab in position while completely removing a major structural component.
Re: Sheet Metal Parts
Can't imagine shipping something like that would be very good to some people.
Re: Sheet Metal Parts
If possible I am a fan of patching with WAY thicker metal than stock.. Eliminate the ability for it to rust thru again in your life time !
However I do understand the desire for correct looking repairs where the stock carpet fits easily as well.
Darrel and I did some floor patches that required two people to make the bends in the metal plate
However I do understand the desire for correct looking repairs where the stock carpet fits easily as well.
Darrel and I did some floor patches that required two people to make the bends in the metal plate
-
- Posts: 408
- Joined: December 27, 2009, 6:03 pm
- Location: durham missouri
Re: Sheet Metal Parts
The big question would be quality. That's a hit or miss subject with LMC.
Every day above ground is a good one