Ignition bezel
Ignition bezel
Is there a way to remove it without scaring it up and not having to by one of those fancy tools off ebay?
-1966 Ford F100, 352, 4 speed, smoke grey, mustang buckets
-2003 Ford Ranger XL, 3.0, 5 speed
-1989 Ford F250, 460, highboy, 4x4
-2003 Ford Ranger XL, 3.0, 5 speed
-1989 Ford F250, 460, highboy, 4x4
You have to insert the key, turn to ACC. Insert a paper clip into the hole in the cylinder and rotate toward the driver door. The cylinder will come out easily.
Now grapand push the rear of the switch under the dash toward the seat and hold the bezel. Rotate the switch about an eighth of a turn and it should pop loose. No tools needed other than the key and a paper clip.
Now grapand push the rear of the switch under the dash toward the seat and hold the bezel. Rotate the switch about an eighth of a turn and it should pop loose. No tools needed other than the key and a paper clip.
I hate Message Boards.
-
- Posts: 11470
- Joined: July 11, 2006, 11:28 am
- Location: Dove Creek, Co. elevation 6842