Wire Ties

Jonas · Post by **Jonas** » March 20, 2008, 7:33 pm

Can anyone point me in the right direction? I need to find the plastic/rubber pieces used under the hood to hold wires in place. They are black, they are pushed into holes in the inner fenders, cowl, etc. Then they have a wire tie build into them. Hope this make sense.

Thanks

needmoretime · Post by **needmoretime** » March 21, 2008, 11:29 am

I believe Flashback Tom has them. You can also hit a swap meet this spring and find a restoration supply (clips,screws,hardware) They have it all. I take an old one and match it up!

Good luck and enjoy the hunt

Wayne

biggus · Post by **biggus** » March 21, 2008, 7:41 pm

Are These what you are looking For?
I bought these from http://www.carolina-classics.com/Detail ... ategory=12

needmoretime · Post by **needmoretime** » March 21, 2008, 8:09 pm

They will work but are not as original if it matters. Depends on the project.

66 POJ · Post by **66 POJ** » March 21, 2008, 9:11 pm

Check Fairlane parts around the same year. I bought some last year and I believe it was from a Fairlane parts supplier. If I run across the paperwork, I'll post.

Wire Ties

Wire Ties

Are these what you are looking for?