i am trying to decide if i want a roll pan or not

[Uncle Skip]

Keith.
Great little how to tutorial.
Why don't you put it in the Hints and Tricks section so it won't get lost for future builders asking about the roll pans.
Yes, Moose, your roll pan did push me and Tom over the edge.
U@ss

[DCarr]

This is the kind of school I like- sittin' in front of the puter lookin' at pictures and reading good, understandable captions. Nice job Keith!

[UNIFAN]

thanks again and to those who are worried about me cutting my other truck bed i wasnt planning on it i may try looking around here in TN for a truck with just those sections good on it or make one from scratch
hello UNIFAN im in TN too what part are u in
and should i weld it in if i do get one or just gap it close
i thought about a hidden hitch and if i have one at all i probably will put it behind the license plate
everybodys truck looks good with them
thanks

Ratrod, where pretty close. I'm in the Boro. Weld it in if you never plan on going back, but if you think you might run a bumper later, or sell it, just bolt it in to make things easier to go back stock

[66 F-100 Ratrod Kustom]

thanks

[66 F-100 Ratrod Kustom]

thanks for the reply UNIFAN i was at the smyrna gun show today

[66 F-100 Ratrod Kustom]

if you use a bed side how far does it go down