Wiston cup 4 speed on Ebay?

64 f100 · Post by **64 f100** » January 16, 2007, 12:41 am

Impressive looking tranny, forget what it's called exactly. Sidloader with fancy cases, supposedly 8 thousand new. Doesn't say what it will bolt up to. Sure sound impreessive though. Bid is at 815 at the moment. Anyone know about what these transmissions are?

Rich

64 f100 · Post by **64 f100** » January 16, 2007, 9:50 am

More information. MidValley racing transmission, item 220071151637. They e-mailed me saying it replaces a super T10, GM?

Rich

jakdad · Post by **jakdad** » January 16, 2007, 10:04 am

The NASCAR transmissions bolt up behind Ford,GM Mopar,Etc.Don't remember what is used for a bell housing. You can switch engines in those cars and not change anything but the engine. Frames, rear ends, trans all same stuff other than gear ratios. I know this is not much help but from my own racing experience, I wouldn't use one of these in a street car. Too noisy for one thing with straight cut gears.

64 f100 · Post by **64 f100** » January 22, 2007, 7:54 pm

Thanks Jim, went to high for a street vehicle anyway. Sure looked like a preccision built unit though.

Rich

6166 Junkyard Dog · Post by **6166 Junkyard Dog** » January 22, 2007, 10:17 pm

I have built a couple of the toploaders & the syncro's were left out sometimes or the brass we could trim down & the small teeth would grind off so did not have to use the clutch when shifting,, Then a company came out with the gears made like that, like Jim says not pratical in a street machine but good for some high performance racing that you need to speed shift without using the clutch since that will slow you down