Page 1 of 1
4x4 owners - who's interested in cab mounts?
Posted: March 10, 2007, 6:42 pm
by NJ2000R
I'm still researching sources for the rubber and associated parts, and if I'm successful, I know a few mentioned they would be interested too....post if you're interested, cost unknown at this time, but I'd imagine making several sets would be cheaper than one set....
Posted: March 10, 2007, 7:57 pm
by YukonCor55
Heck, I just got done changing motor and transfer case mounts...I might as well tackle the cab mounts! Even though mine seem OK, it never hurts to have an extra set. If the cost is reasonable, I'm interested.
Posted: March 10, 2007, 9:06 pm
by ICEMAN6166
not sure what other associated parts are involved unless you mean the cutting and forming tools.
if you need i can take some measurements and pics of the stock rubbers.
definitely i would be interested in a couple sets.
Posted: March 11, 2007, 9:49 pm
by 64 f100
Are these the same mounts used on the bigg trucks? If so, I would be interested in a set. Since I know of none available for the big trucks, there may be a market on Ebay for some also.
Rich
Posted: March 12, 2007, 12:29 pm
by ICEMAN6166
Rich, they are the same ones.
Posted: March 12, 2007, 1:38 pm
by NJ2000R
associated parts would be the metal components: the correct nuts, bolts, and washers....mine were very rusty, and had to be torched off....also, the metal bands and spacers....may as well do it right....
Posted: March 13, 2007, 7:58 pm
by nuwave
I need some for my 64 4x4, count me in.
It has been suggested by another source, to fab the front ones from hockey pucks or an old tire. I have not resorted to this solution, but I may if all else fails..which is the case so far!