Page 1 of 1
Custom trim
Posted: January 3, 2011, 6:48 pm
by TOMJAK11
Will 65/66 custom trim fit a 64?
Tom
Posted: January 3, 2011, 8:29 pm
by Greg D
Put simply - Yes.
The body is basically the same (some differences in the wheel houses though).
I can't remember if the clip holes are in the same places or on the same line though.
Posted: January 3, 2011, 8:47 pm
by Gritsngumbo
It will fit, but will not be "correct"...if that matters to you. I've seen it done on some resto-mod Slicks that looked pretty good (without any emblems).
Posted: January 4, 2011, 4:14 am
by TOMJAK11
Thanks guys
Posted: January 4, 2011, 12:39 pm
by Nick64Slick
I just posted this same question then I found this post. does anyone know if the holes will line up? the truck is already in primer so I'd like to avoid welding up the 64's and adding new ones. about to order some trim but want to make sure. thanks
Posted: January 4, 2011, 1:48 pm
by ICEMAN6166
not 100% on that but i do not think the holes will line up as they are centered in the trim and the 65/66 trim is quite a bit larger than the 63/64.