Slick 60's

Finally got the bed cut off of the uni

why did you cut the bed off?

Very interested in seeing how this turns out!

64f100sixcylinder wrote:why did you cut the bed off?

he wants a south American style slick
as do i

Dan
heres a pic of the bed i cut up in Alaska
i cut the top differently and was in the process of removing the gas tank brace and the other angle piece which i was going to replace with flat stock bars 1" x 3\16" to strengthen the wall some.

The real key is to find a uni where the cab is too far gone..and the box is good enough...

Thanks. I cut it a little on the long side so that I could cut it down to size, since it is easier to take away than to add. My next step is to turn it upside down on sawhorses in front of the shop so I can do repairs on the bottom. I think I can hammer out the dents on the back, but any help is appreciated.

Dan

I finally got the bed off and in front of the shop for some cut and paste

I cut open the torque box. Full of dirt and rust.

After hosing the garbage out. Still work to do.

Gonna enjoy seeing this come around ! loven them split unis .....

The bed is in the shop. El Nino has been at work here making it rain, which is unusual in May. You can see where I reconstructed the piece that holds the sheet metal in place on the lower bed. I used 2 inch angle. I also welded a piece across the front of the bed. I did it as one piece so that it will be straight. I am going to cut the middle out of it and drop it 1/4 inch for the bed floor, which I am going to cut out of my fridge bed.

Is this truck going to be ready for episode 7 ? The Chijawas haven't been spotted in a sand crawler in quite awhile...

I plan on having the body work done by then. The rest is easy stuff. I should have the hyperdrive ready for august 2016.

Dan

I welded in the support for the other side. I now need to weld in the front bed support.



Dan

good deal
keep going at it youll be done by ss
i would flip mine over but no one to help so its up on barrels and blocks

got my gas bottle yesterday so ready to start welding again

while hammering out dents in the wheelwells i started to wonder how many others have done or tried to do this uni bed thing

More work finished. I welded in a solid front piece so that it would be straight. I also cut through it on each side so that it would be cut out around the sheet metal ribs on each side. I cut the center back out so I could weld it back in with the drop necessary for the corrugations in the truck floor.



It needed a 1/4 inch drop, so I welded a spacer made from angle scrap on each side.



On the center piece I cut out the pieces that would cover the ribs and become crap catchers.



I then welded the center back in. I clamped it and did some plug welds so that I would not have to keep clamping it.

Whole lot of watchin goin on

No fridge parts yet. This is all 2 inch angle cut and welded in to replace the original sheet metal. I am going to cut a section out of the fridge bed for the front of the bed floor. I have not made it that far yet.

Dan