Rusted floor

killercoating · Post by **killercoating** » May 30, 2007, 1:56 pm

OK the 14ga. and 11ga. steel is coming tonight. I am worried that the cab might not be sitting right after the rear cab mount went bad, seeing as the front mount is bent. What would be the best way to square everything up before welding the new mount and floor in?

66fordtrucknut · Post by **66fordtrucknut** » May 31, 2007, 4:11 am

My cab was off when I did mine and I rolled my cab on the back and took a bunch of measurements before I cut them off and did one side at a time. and it made repairing the mid brace alot easier too. I cut out the mounts and the floor in one piece so I had a general reference. Good luck.
Charlie