Page 1 of 1
NO OIL IN THE TOP OF THE MOTOR. HELP!!!
Posted: June 29, 2007, 7:58 am
by jva118
A FRIEND IS WORKING ON A 64 WITH A 223 STRAIGHT SIX. THE MOTOR IS A FRESH REBUILD . HE HAS PLENTY OF PRESSURE IN THE CRANKCASE,BUT WHEN YOU REMOVE THE VALVE COVER THERE IS NO OIL. THE MOTOR WAS ALREADY ASSEMBLED WHEN HE GOT IT. HAS ALL RECIEPTS OF REBUILD FROM PREVIOUS OWNER. DOES ANYONE HAVE ANY SUGGESTIONS TO HELP US WITH THIS PROBLEM. THANKS
Posted: June 29, 2007, 8:11 am
by Greg D
There should be 2 tubes in the top of the rocker shaft that curve down into holes in the cylinder head. These are the oil feed for the valve train, are they in place? Are they plugged?
Posted: June 29, 2007, 8:15 am
by jva118
they are free and clear. no oil is getting to the tubes. any other suggestions
Posted: June 29, 2007, 8:40 am
by fmartin_gila
The front tube on the rocker shaft is a drainback. The rear tube should have pressure from below. If you don't have pressure to the rear tube, the # 3 camshaft bearing was prolly put in without lining up the feed hole. I would suggest to pull the cam and check before any damage, if not already done.
Fred
Posted: June 30, 2007, 6:06 pm
by 64 f100
There is another cure for the not oiling on the top end. You can put an external oiler line from the block.
Rich
eng
Posted: June 30, 2007, 11:32 pm
by jeffw
hey I had the same problem,, turns out hedauls did not put the cam bearing in properly,, youd better fix her,, I lost my rockers, bent a pushrod, and the rocker shaft was shot to hell,,
the boys at headauls went as far as to say they did'nt assemble my motor
that was the first time I was I talked to a bold face lier, but on a happy note they replaced all mentioned above, down to the gaskets, My buddy fixed her up and she rums like a gem!!! just like fmartin said,, that'll cure you lube needs
Posted: July 1, 2007, 6:10 pm
by jva118
LOOKS LIKE THE CAM BEARING WAS LINED UP,BUT THERE IS NO GROOVE IN THE CAM OR THE BEARING TO RECEIVE OIL. IS THIS COMMON ON THIS MOTOR?I AM SURE NOW THAT THIS IS THE PROBLEM, JUST WHAT TO DO TO FIX IT. GET A NEW BEARING OR MILL A GROOVE INTO THE CAM. ANY SUGGESTIONS?
Posted: July 2, 2007, 1:57 am
by Greg D
Is there a bearing with a groove in the wrong position in the block? Maybe just got a wrong bearing in the set?
Posted: July 2, 2007, 12:29 pm
by Moose
Had a similar problem with my 390 a few years back. Installed a different cam, fired it up and no oil pressure!
Turned out to be the distributor was not seated onto the oil pump drive shaft. My engine ran for over an hour with no oil coming to the heads at all! The engine was running perfectly fine too. Might want to check and see if the drive is fully engaged in the dristributor.
Moose
Posted: July 2, 2007, 1:26 pm
by DocDave
How bout this.
Headgasket installed upside down. Does it overheat at all?
If it was flipped the water jackets may line up but not the oil galleries
Just a thought
At least I think it was a thought, at my age you really cant tell any more!
Dave