Slick 60's

I'm looking at re-wiring my truck when I do the body/fram swap. I want to buy the whole thing.

Where would be the best place to buy or any suggestions on where to look?

Thanks!

American Autowire makes a good kt. It is what I used in my truck. EZ Wiring makes a good kit and about half the cost of the A.A. kit. It just depends on what you want. The EZ wiring kit seems to be real popular with most here.

Kevin

I would suggest a Rebel Wire harness to anyone.

http://www.rebelwire.com/

The kits are made in the USA. I am using one(a 9+3 kit) currently in my Unibody project and it is very well made and has good instructions. Definately worth checking out.

On the American Wire kit I noticed it comes with a Headlight switch and a Ign Switch.... Did you use those in your setup..
Did it make it alot easier to use those..? I don't want to hack my headlight switch I really go with one that comes with the kit.

I will only be running the basic features that came with the truck and maybe a radio.

This is the kit I was going to go with... What do you think?

http://www.ebay.com/itm/230474040812?_t ... 97.c0.m619

I used the headlight switch that came with the American Wire kit. My dash isn't stock so it didn't matter if I had the stock switch in the dash. The headlight switch was easy to hook up because it comes with a plug but I still had to hook it up to the column for the hi/low switch. I didn't use the ignition switch that came with it because I had a column with the key in it.

Kevin

I have a stock setup.... Was the wire long enough on the kit? I have heard people complain they don't reach to the taillights?

cwindsor wrote:I have a stock setup.... Was the wire long enough on the kit? I have heard people complain they don't reach to the taillights?

All of the wires were long enough in my kit but mine is a short bed. I don't remember anything being that close to not work on a long bed.

Kevin

I have an American auto wire kit. For all the engine compartment and other connections that are exposed to the elements, I spent a little extra $$ and converted to the weather tight connectors. I also used shrink wrap on all the others.