Page 1 of 1
Were the rubber mats screwed in around the perimeter
Posted: January 31, 2015, 7:54 pm
by 66camperspecial
My 66 had the rubber mat screwed in on the edge at the firewall and seat and wondering if it was done at the factory.
Re: Were the rubber mats screwed in around the perimeter
Posted: January 31, 2015, 9:29 pm
by 64 f100
By the time I've normally gotten the trucks I've found the screw but nothing but holes in the mats as a general rule. I believe the mats were screwed on to help hold in place. I've found far to many of the screw to believ otherwise.
Rich
Re: Were the rubber mats screwed in around the perimeter
Posted: February 1, 2015, 4:50 pm
by 66camperspecial
There is a local junkyard that has a few and will have to look at them and see if they have screws too.
Re: Were the rubber mats screwed in around the perimeter
Posted: February 1, 2015, 8:05 pm
by shortwide
Re: Were the rubber mats screwed in around the perimeter
Posted: February 2, 2015, 7:27 pm
by 808F250
When I tore the original mat out of my 65 it had them. 2 at the top of the passenger side, 1 at the top of the driver... None at the seat.
Re: Were the rubber mats screwed in around the perimeter
Posted: February 3, 2015, 5:25 pm
by 66camperspecial
I wonder if its something only a few assembly plants did,mine is originally from Iowa.
Re: Were the rubber mats screwed in around the perimeter
Posted: February 5, 2015, 8:56 am
by shortwide
66camperspecial wrote:I wonder if its something only a few assembly plants did,mine is originally from Iowa.
That is not only possible, but probable.
I've come across many examples of such minor variations with Fords manufactured prior to the heavily automated assembly lines.
Re: Were the rubber mats screwed in around the perimeter
Posted: February 12, 2015, 10:04 am
by 64 f100
Just got through installing the windshield in the 65 I have for sale, and looked at the floor covering. It has four screws along the top and some screws in the corner down below the seat. I'm thinking the mats would not lay down right and the screws were added to make the mat lay in place right until it conformed.
Rich
Re: Were the rubber mats screwed in around the perimeter
Posted: February 12, 2015, 8:19 pm
by 6166 Junkyard Dog
on my truck I took a original floor mat out of another truck < no screws > and re-installed in my Mercury < no screws > but put back on the aluminum scuff plates that was there , and then I put over top a Ford Accessory Black Rubber Mat
Re: Were the rubber mats screwed in around the perimeter
Posted: February 13, 2015, 7:33 pm
by ICEMAN6166
i have parted out many slicks, some had screws some did not
same with bumpsides
Re: Were the rubber mats screwed in around the perimeter
Posted: February 14, 2015, 9:43 am
by 66camperspecial
Since the holes are there I will put screws back in,mine originally did not come with sill plates but I am going to find a set to put in it to help keep the mat from moving around.