Slick 60's

I am installing a different engine.
What is the angle of the output shaft of the transmission?
My pinion angle is 6 degrees with no engine.
Thank you!

ive always just leveled engine in truck by carb. mounting plate, tail shaft angle is what it is, drive shaft u joints should take care of diffrences ?

Danny

Try looking over the Body Builders Layout Books...they might help. While they don't specifically give a measurement in degrees, they do specify how much lower the transmission output shaft centerline needs to be below the top of the frame.

http://www.fordification.info/tech/bodybuilder.htm

Stock angle is 4.66 degrees...its on those frame dimension sheets, but hard to pick out.

third66go wrote:Stock angle is 4.66 degrees...its on those frame dimension sheets, but hard to pick out.

Thank you
That is what I needed to know