need a new column drop for my steering column

61ford · Post by **61ford** » November 3, 2007, 8:35 pm

guys i was doing a mockup today with my 77 column that im going to use with the crown vic and i need me a 77 column drop.anyone know where to look for the u joints?

Slick Fan · Post by **Slick Fan** » November 4, 2007, 10:12 am

I'd try these guys; http://www.flaming-river.com/
If they don't have the application you need listed, they may be able to work out something for you on the phone. Guys on other sites I'm on have had decent luck with them.

cdherman · Post by **cdherman** » November 4, 2007, 10:51 pm

Can you describe a little better what you mean by a "column drop"? I have hoarded some parts for columns recently and might be able to help, if I could understand what you were needing......

61ford · Post by **61ford** » November 5, 2007, 1:38 pm

the column drop is the piece that holds the column up and that piece then bolts to the bottom side of the dash my stock one doesnt allow the column to go as far up as it should

GDG · Post by **GDG** » November 5, 2007, 2:17 pm

I'm planing to cut mine to fit and weld new attachments to the top of it.
Doug

Slick Fan · Post by **Slick Fan** » November 5, 2007, 2:36 pm

BTW, that link I posted is just to answer the u-joint part of your question, I doubt that place would have any idea of the bracket you're talking about.

61ford · Post by **61ford** » November 5, 2007, 9:10 pm

thanks i totally forgot about them truck is finally starting to come together a little bit so ive been gathering lots of parts lately