need a measurement please

spstack · Post by **spstack** » January 1, 2010, 8:46 pm

need a measurement for my 63 for the dome light need a measurement from the top to the rear window to the outside of the bezel hope everyone new year is a good one

Ford blue blood · Post by **Ford blue blood** » January 2, 2010, 3:50 pm

Not sure if they will be the same, my 61 two piece head liner is as follows, the total width of the panel at the dome light is 4 1/2", the bottom of the dome light to the rubber is 1 1/4" and it is 1 3/4" to the bottom of the panel. Hope this helps......

ICEMAN6166 · Post by **ICEMAN6166** » January 2, 2010, 7:01 pm

61-63 are the same dome light. 64-72 use a different light.

spstack · Post by **spstack** » January 3, 2010, 8:23 pm

thanks i have a rod doors headliner and needed the measurment for light placement so 1 1/4 up to the bottom of the bezel and your correct the 61-63 uses a angled bezel and later years went to a flat one thaks again guys