Custom trim

TOMJAK11 · Post by **TOMJAK11** » January 3, 2011, 6:48 pm

Will 65/66 custom trim fit a 64?

Tom

Post by **Greg D** » January 3, 2011, 8:29 pm

Put simply - Yes.
The body is basically the same (some differences in the wheel houses though).
I can't remember if the clip holes are in the same places or on the same line though.

Gritsngumbo · Post by **Gritsngumbo** » January 3, 2011, 8:47 pm

It will fit, but will not be "correct"...if that matters to you. I've seen it done on some resto-mod Slicks that looked pretty good (without any emblems).

TOMJAK11 · Post by **TOMJAK11** » January 4, 2011, 4:14 am

Thanks guys

Nick64Slick · Post by **Nick64Slick** » January 4, 2011, 12:39 pm

I just posted this same question then I found this post. does anyone know if the holes will line up? the truck is already in primer so I'd like to avoid welding up the 64's and adding new ones. about to order some trim but want to make sure. thanks

ICEMAN6166 · Post by **ICEMAN6166** » January 4, 2011, 1:48 pm

not 100% on that but i do not think the holes will line up as they are centered in the trim and the 65/66 trim is quite a bit larger than the 63/64.