free cv clip in edmonton

cooter · Post by **cooter** » January 19, 2011, 9:36 am

ihave a 05 crown vic front subframe to give to a slick member, located 10 minutes north of Edmonton. Must be picked up.

65TremecGT · Post by **65TremecGT** » January 19, 2011, 4:03 pm

Good deal, wish i was closer!

61 Merc · Post by **61 Merc** » January 19, 2011, 9:21 pm

Sent you a PM, I am interested in it.

Dean

TOMJAK11 · Post by **TOMJAK11** » January 19, 2011, 9:24 pm

Just wanted to say thanks for the offer. That is very generous of you.

Tom and Jakson

cooter · Post by **cooter** » January 19, 2011, 11:17 pm

well i bought it but will be using a tubular set up instead so it may as well go to a fellow slickster, it does me no good sitting on my floor.

64 f100 · Post by **64 f100** » January 20, 2011, 9:48 am

This is an extremely generous offer, nice of you to offer. Only wish I were closer also. These run into the 100's of dollars around here.

Rich

cooter · Post by **cooter** » January 27, 2011, 9:15 pm

going going, gone. Hope it goes to good use 61 merc!

61 Merc · Post by **61 Merc** » January 27, 2011, 9:41 pm

It will go to good use, just as soon as I find it. I plan on keeping it for another project. Hope your project is going good.

Dean

cooter · Post by **cooter** » January 27, 2011, 11:08 pm

my project would be going better if i was working on it instead of every one elses project! oH well hopefully march will be looking better.

The Big M · Post by **The Big M** » January 28, 2011, 5:50 pm

Good deal!

Hey Dean, let me know if you're passing through Cowtown on your way to pick up the clip. I still have that ECU for you. I'll PM you my new contact info.